{"id":272,"date":"2012-07-30T15:05:03","date_gmt":"2012-07-30T15:05:03","guid":{"rendered":"http:\/\/rglinuxtech.com\/?p=272"},"modified":"2012-07-30T15:05:03","modified_gmt":"2012-07-30T15:05:03","slug":"kernel-3-5-hang-on-the-dreamplug","status":"publish","type":"post","link":"https:\/\/rglinuxtech.com\/?p=272","title":{"rendered":"Kernel 3.5 ‘hang’ on the Dreamplug.."},"content":{"rendered":"

Been trying the ‘released’ version of kernel 3.5 on my Dreamplug, and at first the hang appeared to be due to the fact that 3.5 didn’t detect the Marvell Orion USB controller, but now there is another problem (see Update below..):<\/p>\n

‘Good’ boot (3.4.5):<\/p>\n

mv_xor mv_xor.3: Marvell XOR: ( xor fill cpy )
\nSerial: 8250\/16550 driver, 2 ports, IRQ sharing disabled
\nserial8250.0: ttyS0 at MMIO 0xf1012000 (irq = 33) is a 16550A
\nconsole [ttyS0] enabled
\nbrd: module loaded
\nloop: module loaded
\nehci_hcd: USB 2.0 ‘Enhanced’ Host Controller (EHCI) Driver
\norion-ehci orion-ehci.0: Marvell Orion EHCI
\norion-ehci orion-ehci.0: new USB bus registered, assigned bus number 1
\norion-ehci orion-ehci.0: irq 19, io mem 0xf1050000
\norion-ehci orion-ehci.0: USB 2.0 started, EHCI 1.00
\nhub 1-0:1.0: USB hub found
\nhub 1-0:1.0: 1 port detected
\nInitializing USB Mass Storage driver…
\nusbcore: registered new interface driver usb-storage
\nUSB Mass Storage support registered.
\nusbcore: registered new interface driver ums-datafab
\nusbcore: registered new interface driver ums-freecom
\nusbcore: registered new interface driver ums-jumpshot
\nmousedev: PS\/2 mouse device common for all mice
\nrtc-mv rtc-mv: rtc core: registered rtc-mv as rtc0
\ni2c \/dev entries driver
\nsdhci: Secure Digital Host Controller Interface driver
\nsdhci: Copyright(c) Pierre Ossman
\nmmc0: mvsdio driver initialized, lacking card detect (fall back to polling)
\nsdhci-pltfm: SDHCI platform and OF driver helper
\nusbcore: registered new interface driver usbhid
\nusbhid: USB HID core driver
\noprofile: hardware counters not available
\noprofile: using timer interrupt.
\nTCP: cubic registered
\nNET: Registered protocol family 17
\nlib80211: common routines for IEEE802.11 drivers
\nRegistering the dns_resolver key type
\nrtc-mv rtc-mv: setting system clock to 2012-07-30 18:21:13 UTC (1343672473)
\nWaiting 10sec before mounting root device…
\nmmc0: new high speed SDIO card at address 0001
\nusb 1-1: new high-speed USB device number 2 using orion-ehci
\nhub 1-1:1.0: USB hub found
\nhub 1-1:1.0: 4 ports detected
\nusb 1-1.1: new high-speed USB device number 3 using orion-ehci\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0<\/address>\n

…………\u00a0\u00a0 boot continues successfully\u00a0 ……………<\/p>\n

‘Bad boot (3.5.0)<\/p>\n

mv_xor mv_xor.3: Marvell XOR: ( xor fill cpy )
\nSerial: 8250\/16550 driver, 2 ports, IRQ sharing disabled
\nserial8250.0: ttyS0 at MMIO 0xf1012000 (irq = 33) is a 16550A
\nconsole [ttyS0] enabled
\nbrd: module loaded
\nloop: module loaded
\nehci_hcd: USB 2.0 ‘Enhanced’ Host Controller (EHCI) Driver
\nohci_hcd: USB 1.1 ‘Open’ Host Controller (OHCI) Driver
\nInitializing USB Mass Storage driver…
\nusbcore: registered new interface driver usb-storage
\nUSB Mass Storage support registered.
\nmousedev: PS\/2 mouse device common for all mice
\nrtc-mv rtc-mv: rtc core: registered rtc-mv as rtc0
\ni2c \/dev entries driver
\nsdhci: Secure Digital Host Controller Interface driver
\nsdhci: Copyright(c) Pierre Ossman
\nmmc0: mvsdio driver initialized, lacking card detect (fall back to polling)
\nsdhci-pltfm: SDHCI platform and OF driver helper
\nusbcore: registered new interface driver usbhid
\nusbhid: USB HID core driver
\noprofile: hardware counters not available
\noprofile: using timer interrupt.
\nTCP: cubic registered
\nNET: Registered protocol family 17
\nlib80211: common routines for IEEE802.11 drivers
\nKey type dns_resolver registered
\nrtc-mv rtc-mv: setting system clock to 2012-07-30 18:27:10 UTC (1343672830)<<<<\u00a0\u00a0 HANG\u00a0 >>>><\/p>\n<\/address>\n

Update:\u00a0\u00a0 Fixed the orion-ehci detection, but still doesn’t boot..\u00a0\u00a0 Back to the drawing board..<\/p>\n

ehci_hcd: USB 2.0 ‘Enhanced’ Host Controller (EHCI) Driver
\norion-ehci orion-ehci.0: Marvell Orion EHCI
\norion-ehci orion-ehci.0: new USB bus registered, assigned bus number 1
\norion-ehci orion-ehci.0: irq 19, io mem 0xf1050000
\norion-ehci orion-ehci.0: USB 2.0 started, EHCI 1.00
\nhub 1-0:1.0: USB hub found
\nhub 1-0:1.0: 1 port detected
\nInitializing USB Mass Storage driver…
\nusbcore: registered new interface driver usb-storage
\nUSB Mass Storage support registered.
\nusbcore: registered new interface driver ums-datafab
\nusbcore: registered new interface driver ums-freecom
\nusbcore: registered new interface driver ums-jumpshot
\nmousedev: PS\/2 mouse device common for all mice
\nrtc-mv rtc-mv: rtc core: registered rtc-mv as rtc0
\ni2c \/dev entries driver
\nsdhci: Secure Digital Host Controller Interface driver
\nsdhci: Copyright(c) Pierre Ossman
\nmmc0: mvsdio driver initialized, lacking card detect (fall back to polling)
\nsdhci-pltfm: SDHCI platform and OF driver helper
\nusbcore: registered new interface driver usbhid
\nusbhid: USB HID core driver
\noprofile: hardware counters not available
\noprofile: using timer interrupt.
\nTCP: cubic registered
\nNET: Registered protocol family 17
\nlib80211: common routines for IEEE802.11 drivers
\nKey type dns_resolver registered
\nrtc-mv rtc-mv: setting system clock to 2012-07-30 22:16:57 UTC (1343686617)
\n<<\u00a0 HANG\u00a0\u00a0 >><\/strong><\/address>\n","protected":false},"excerpt":{"rendered":"

Been trying the ‘released’ version of kernel 3.5 on my Dreamplug, and at first the hang appeared to be due to the fact that 3.5 didn’t detect the Marvell Orion USB controller, but now there is another problem (see Update below..): ‘Good’ boot (3.4.5): mv_xor mv_xor.3: Marvell XOR: ( xor fill cpy ) Serial: 8250\/16550 driver, 2 …<\/span> Continue reading →<\/span><\/a><\/p>\n","protected":false},"author":1,"featured_media":0,"comment_status":"open","ping_status":"closed","sticky":false,"template":"","format":"standard","meta":{"_monsterinsights_skip_tracking":false,"_monsterinsights_sitenote_active":false,"_monsterinsights_sitenote_note":"","_monsterinsights_sitenote_category":0,"footnotes":""},"categories":[5,6,7,14,16],"tags":[45,136,184,1173,256],"class_list":["post-272","post","type-post","status-publish","format-standard","hentry","category-compilation","category-crash-and-burn","category-dreamplug","category-kernel","category-linux-arm","tag-3-5","tag-dreamplug-2","tag-hang","tag-kernel","tag-marvell-orion"],"_links":{"self":[{"href":"https:\/\/rglinuxtech.com\/index.php?rest_route=\/wp\/v2\/posts\/272","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/rglinuxtech.com\/index.php?rest_route=\/wp\/v2\/posts"}],"about":[{"href":"https:\/\/rglinuxtech.com\/index.php?rest_route=\/wp\/v2\/types\/post"}],"author":[{"embeddable":true,"href":"https:\/\/rglinuxtech.com\/index.php?rest_route=\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"https:\/\/rglinuxtech.com\/index.php?rest_route=%2Fwp%2Fv2%2Fcomments&post=272"}],"version-history":[{"count":0,"href":"https:\/\/rglinuxtech.com\/index.php?rest_route=\/wp\/v2\/posts\/272\/revisions"}],"wp:attachment":[{"href":"https:\/\/rglinuxtech.com\/index.php?rest_route=%2Fwp%2Fv2%2Fmedia&parent=272"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"https:\/\/rglinuxtech.com\/index.php?rest_route=%2Fwp%2Fv2%2Fcategories&post=272"},{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/rglinuxtech.com\/index.php?rest_route=%2Fwp%2Fv2%2Ftags&post=272"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}